LaserMatrix Series Troubleshooting Guide
- Problem:
- Printout Fails to Appear in PostScript (READY may first flash with DATA off. READY will return to steady on but no printout)
| Probable Cause | Solution |
|
PostScript Error Has Flushed File(s)
|
This can occur because the PostScript file(s) either a) lack an end-of-transmission (EOT) command (04H) at the beginning and end of each file*, b) are PostScript level II**, or c) are corrupted. In the case of corrupted files, you may have to cycle power off and on to recover.
|
|
PCL Print File Was Sent to Printer in PostScript Mode
|
Check that the emulation selection on the printer and host agree. Send only PCL print files in PCL mode.
|
*This allows each good file to print, but continues to flush any file that requires code analysis. Try setting "Emu= PS Emul"rather than "Emu= Auto"in the Configuration Menu.
**The optional PostScript emulation supports PostScript level I.
|
