| Probable Cause | Solution |
|
Low Toner
|
If "Toner Low"is displayed, refill developer with toner.
|
|
Print Density Setting Too Low
|
Set the print density dial to a higher setting.
|
|
Broken Developer Drive Gear
|
Check drive gear (Page 7-51).
|
|
Drum Cartridge Nearing End of Life
|
Check "Drum Ft= ..."in the Extended Configuration Menu. On the average, the drum cartridge should be replaced at about 27,600 ft.
|
|
Broken or Dirty Transfer Corona Wire
|
Check. If not broken, clean. If necessary, call for service.
|
|
Filmed-Over or Worn-Out Fuser Roller
|
Attempt to clean. Replace felt cleaning pad. If necessary, replace fuser heat & pressure rollers.
|
